Filter
Top Products
2-24
Installing the MDW 9030P Pocketphone
Installing Multiple CarriersInstalling Multiple Carriers
Installing Multiple CarriersInstalling Multiple Carriers
Installing Multiple Carriers
■
Install each carrier high on wall, leaving 6–12 inches (15.2–30.5 cm) between
antennas and ceiling
■
Install each carrier 1 foot (0.3 m) optimal to 4 feet (1.2 m) from its
neighboring carrier
■
Never install or remove a radio module from a carrier that is plugged into a wall
outlet (hot insertion)
■
See “Key Components” earlier in this chapter for additional picture detail
Perform the tests described in "Wireless Test
Mode" earlier in this chapter to determine the
optimal placement of the radio module. To perform
the tests, all you need is an electrical outlet for the
radio module and a charged battery pack in the
handset.
1
2
Check to make sure the carrier’s power cord is
unplugged from the wall outlet before continuing.
3
Choose a location backed by a wooden stud for
the carrier (if unavailable, use toggle bolts
instead of the supplied wood screws).
IMPORTANT:IMPORTANT:
IMPORTANT:IMPORTANT:
IMPORTANT:
The leftmost carrier must be the control carrier.
See "Setting the Control/Expansion DIP Switch"
earlier in this chapter.
Place the carrier against the wall, leaving enough
room to the right for additional carrier(s) if applicable.
Hold the carrier straight; use a level if needed. Using a
nail or pencil, mark screw locations through the four
wall-mount holes. Start the screws, leaving the screw
heads protruding approximately
1
/
2
" (12 mm) from the
wall.
1 2 3 4
6
4
T
RANS
T
ALK
21
O N
21
O N
5
CAUTION
U
S
E
O
N
L
Y
A
T
&
T
C
A
B
L
E
P
⁄N
8
47
667896
IN
OUT
OUT OF SYNC
4
Repeat Steps 1 through 3 for each carrier.
Place the carrier over the screws, then slide it
downward to lock it into place. Be sure that the
leftmost carrier is the control carrier. Tighten the
screws. Repeat for each carrier.
5
4