Filter
Top Products
Installing the MDW 9030P Pocketphone
2-31
Changing the Communications System SettingChanging the Communications System Setting
Changing the Communications System SettingChanging the Communications System Setting
Changing the Communications System Setting
The communications system you use determines what information the MDW 9030P Pocket-
phone can display and how the phone lines and programmable/intercom/drop buttons are
identified (see "Button Mapping" in Chapter 6, "MDW 9030P Pocketphone Compatibility").
The MDW 9030P is factory-set to work with the PARTNER communications system. If you
are using PARTNER as your communications system, skip this section; if you are
using a different communications system, you will need to change the setting.
To change the communications system setting, use the following procedure to enter Local
Mode and then Button Mapping Mode:
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding " , press O.
The handset beeps twice, and the top line of the display shows LCL:P (unless you have
already changed it from the default setting).
4. Press and hold "M" (6) for three seconds to enter Button Mapping Mode.
The handset display shows one of the following:
MAP:P PARTNER systems
MAP:D DEFINITY systems, System 25, System 75, and System 85
MAP:M1 All MERLIN systems (except MERLIN 410 and MERLIN 820),
including MERLIN LEGEND
MAP:M2 MERLIN 410 and MERLIN 820
5. Press " repeatedly to cycle through the settings until the display appropriate for your
communications system is shown.
6. Press O when the correct setting is displayed.
The top line of the display shows information appropriate to the communications system
you are using.
7. To verify your setting, repeat Steps 1–3. The top line of the display should appear as
follows, depending upon your communications system:
PARTNER systems: LCL:P
DEFINITY systems, System 25, System 75, LCL:D
and System 85
All MERLIN systems (except MERLIN 410 and LCL:M1
MERLIN 820)
MERLIN 410 and MERLIN 820 LCL:M2
For a description of the button mapping between the MDW 9030P Pocketphone and the
wired telephones for your communications system, or to program features on buttons, see
"Button Mapping" in Chapter 6.