Filter
Top Products
3-8 Using the MDW 9030P Pocketphone
AntennaAntenna
AntennaAntenna
Antenna
The MDW 9030P Pocketphone comes with a user-replaceable, flexible, retractable antenna.
For maximum range and voice quality, always fully extend the antenna before placing or
answering a call. You can receive a call (if you are within range of the radio module) without
extending the antenna, but you may get a RANGE indication. The antenna must be fully
extended for optimal performance.
Changing the Handset SettingsChanging the Handset Settings
Changing the Handset SettingsChanging the Handset Settings
Changing the Handset Settings
You can use Local Mode to change the handset settings for these functions:
■
Communications system button mapping
■
Vibrator
■
Line Preselection
■
Alerter
Local Mode also gives you access to Local Test Mode (which enables you to test the
alerter, vibrator, and display) and Wireless Test Mode (which enables you to test sound
clarity, signal strength, and voice quality). While in Local Mode, the MDW 9030P can still
receive notification of incoming calls.
To access Local Mode, use the following procedure:
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding ", press O.
The handset beeps twice, and the display shows the handset settings. For example,
the following display indicates that the handset:
■
Is using button mapping for a PARTNER switch
■
Has the vibrator and Line Preselection enabled
■
Has the alerter disabled
To exit Local Mode, press O.
Changing the Communications System Button Mapping SettingChanging the Communications System Button Mapping Setting
Changing the Communications System Button Mapping SettingChanging the Communications System Button Mapping Setting
Changing the Communications System Button Mapping Setting
If the MDW 9030P Pocketphone is set to use the wrong communications system, an error
message saying CHANGE BUTTN MAP shows on the top line of the handset display each
time the O button is pressed. If you see this message, use the procedure described
in "Changing the Communications System Setting" in Chapter 2 to specify the correct
communications system setting.