Filter
Top Products
3-20 Using the MDW 9030P Pocketphone
The color of the battery charger's LEDs indicates the state of the corresponding battery
pack, as shown in the following table:
NOTE:NOTE:
NOTE:NOTE:
NOTE:
Before you use the MDW 9030P Pocketphone handset for the first time, the battery
pack must be charged.
Battery charger
LED shows...
If it is the SPARE LED,
the battery pack in the
Spare battery
compartment...
If it is the HANDSET
LED, the battery pack
in the Handset...
If it is the REFRESH
LED, the Refresh
button was pressed,
and the Handset
battery pack...
Steady orange Is charging Is charging N/A
Steady green Is fully charged Is fully charged N/A
Flashing red
* See note.
Has one of the
following problems:
• Is not seated
properly in the
charger
• Has dirty contacts
• Is defective
Has one of the
following problems:
• Is not seated
properly in the
charger
• Has dirty contacts
• Is defective
N/A
Steady red Is in the Discharge
portion of the Refresh
cycle.
Is in the Discharge
portion of the Refresh
cycle.
Is in the Discharge
portion of the Refresh
cycle.
*Note: If
either
the SPARE LED or the HANDSET LED is flashing red,
both
battery packs
must be removed from the charger to clear the flashing-red condition. Address the possible
problems for one battery pack at a time to determine whether one is bad.