Filter
Top Products
Using the MDW 9030P Pocketphone 3-11
Enabling or Disabling the AlerterEnabling or Disabling the Alerter
Enabling or Disabling the AlerterEnabling or Disabling the Alerter
Enabling or Disabling the Alerter
The alerter is an audible signal to notify you of an incoming call. If a call comes in while the
phone is idle, the handset rings. If you are already on a call, the handset chirps softly. You
can adjust the volume of the alerter by pressing the "+" button or the "–" button on the side
of the handset when the phone is turned off. You can enable or disable the alerter using the
following procedure:
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating you
are in Local Mode. (While in Local Mode, the MDW 9030P can still receive notification
of incoming calls.)
If the alerter is disabled, the No Ring icon (a bell with a line through it) appears in the
second line of the display. For example:
If the alerter is enabled, the icon is not displayed. For example:
4. Press "A" (2) on the dialpad to enable or disable the alerter.
5. Press O to exit Local Mode.
Note:Note:
Note:Note:
Note:
Both the alerter and the vibrator can be disabled at the same time. In this case the only
notification you have of an incoming call is that a line status indicator (a truncated
triangle or a rectangle, depending on your communications system) flashes in the
display.
ON
ON