Filter
Top Products
139
Note:
For safety, do not handle a damaged or leaking LiIon battery.
Acknowledging Special Precautions and Industry Canada Notice
Cautions
Any changes or modifications to your phone not expressly approved in this document could void your warranty for this
equipment, and void your authority to operate this equipment. Only use approved batteries, antennas and chargers. The
use of any unauthorized accessories may be dangerous and void the phone warranty if said accessories cause damage
or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting,
bending or sitting on it.
Information to User
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient / relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy absorbed in the head of a user of a wireless
handset.
The SAR value of a phone is the result of an extensive testing, measuring and calculation process. It does not represent
how much RF the phone emits. All phone models are tested at their highest value in strict laboratory settings. But when
in operation, the SAR of a phone can be substantially less than the level reported to the FCC. This is because of a