Filter
Top Products
96
Customizing Your Remote
1. From the top of the main screen, tap
Remote
Control
➔
Set Up Now
.
2. From the
Select your TV brand
screen, tap your TV’s
manufacturer name.
•
If you have a brand of TV not listed or you are using a projector,
select from one of the following two options. Choose from
either
Other TV Brands
or
I Have a Projector
.
3. Aim your device at the TV and tap
Power
to
confirm the set up process completed successfully and
the correct TV IR codes were selected.
Note:
The process of the initial TV activation can take up to 10
seconds. Please do not press the button again.
4. If the TV turned on, tap
Yes, this code works
.
– or –
If the TV did not turn on after tapping
Power
and
waiting 10 seconds, tap
No, test next code
or
Send this code again
.
5. From the
Select your channel source
screen, select the
entry that corresponds to your current channel control
method:
• Set-top Box
: selected when channel changes are
accomplished using a receiver box. Channels are not changed
with the TV remote but rather through the receiver/box.
• My xxx TV
: selected when a signal is fed directly into the TV
and no box is used. Channels are changed directly on the TV by
using the TV remote and not a box’s remote.
Note:
Try matching your current channel selection method.
6. Select the Satellite Box Brand from the available list.
For example, DirectTV
®
.
•
If your brand does not display in the list, tap
Show other
brands
and follow the on-screen instructions.
Important!
You must configure your set top box for IR
communication with your device. If you do not
select
More Info..
below and follow the on-screen
instructions you may not be able to properly use
the application.