A SERVICE OF

logo

6
6 - 1
No. 99MBC071A
This chapter describes the setup method and functions provided with the
I/O analog interface and RS-232C interface of this unit.
INTERFACE UNIT
6.1 Standard Interface
6.1.1 I/O Analog Interface
Below is a description of the I/O analog output interface.
This interface is used to communicate with a PC, programmable controller, or relay circuitry
by means of sequential signals. Since it can also capable of analog output, which may be
used for feedback controls and continuous recording of workpiece deviations.
6.1.1.1 External view of the connector
B1
B1 B2 B3 B4 B5
B6
B6
A1 A2 A3 A4 A5
A6
A6
A1
Open the protection cover of the terminal block to access
to the terminals. At your wiring use the supported signal-
name seals that correspond to each terminal number for
identification.