4 - 23
No. 99MBC071A
4. SETTING UP THE MEASURING CONDITIONS
4.5 Setting Up the Functions
Make measurement-related setups based on the conditions set in Section 4.1, “Basic Setup”.
4.5.1 Outline of the function setup mode
SET
SET SETSET
( )
Ready state
Function No.
F0
Setup contents
Setting the segment
In the basic setup mode, first set whether the workpiece is an opaque or transparent object. If it is an
opaque object, then it is possible to specify the number of segments and edges to be measured.
With the edge specification a multiple-pin workpiece can be measured automatically.
• Segment specification: (Opaque object: 1 to 7, Transparent object: 1 to 3)
Edge specification: (Manual: / Automatic: / Automatic: / Automatic: )
Start edge : (Between edge number 1 and 254 )
Finish edge : (Between edge number 2 and 255)
F1 Setting the measurement interval (measurement time)
In the basic setup mode either of the two setting methods can be selected.
• Arithmetical average: (1 to 2048)
Moving average: (32 to 2048)
F2 Setting the GO/NG judgment criteria
In the basic setup mode either of the three setting methods can be selected.
In addition, if the abnormal value elimination function will be specified, the limits
(Lower abnormal limit: → Upper abnormal limit: → Abnormal value count: )
for this abnormal value elimination should be set prior to other setup items.
• Lower limit : → Upper limit:
Multi-limit selection 1: → Multi-limit selection 2: → Multi-limit selection 3: →
Multi-limit selection 6:
Target value : → Lower tolerance limit: → Upper tolerance limit:
F3 Setting the reference value
In the basic setup mode it is possible to copy the setup data of a target value to the reference value.
If this is done the setup guidance for the reference value is not displayed.
• Reference value: → Gain: (1 to 3)
Gain: (1 to 3)
F4 Setting the offset and mastering
Both the offset and mastering can be set.
• Offset: → Direction: (0 , 1) → Mastering:
F5 Setting the data output condition
Data output condition: (0 to 9) : If 1, 3 or 5 is selected →
Periodic data output: (0 to 999)
F6 Sample measurement
Number of samples: (0 ~ 999) → Calculation item:
(Mean: / Maximum value: / Minimum value: / Range: )
Note2
Note1
Note1
