3 - 23
No. 99MBC071A
3. DISPLAYS AND KEY OPERATIONS
3) Display LED
• W.P. (Work Position) LED
LED segments corresponding to a region shaded by the workpiece, which blocks the
laser beam, will turn off. This is used to check if the workpiece is located in the center
of the measuring region.
• LD oscillation LED
LASER EMISSION : Indicates that the laser in the Measuring Unit connected to the
“TRANSMITTER-1” connector is oscillating.
• GO/NG judgment LED
1. -NG : Turns on if the measured data is -NG.
2. GO : Turns on if the measured data is GO.
3. +NG : Turns on if the measured data is +NG.
• RUN LED
Turns on if a single-run measurement, continuous-run measurement or continuous-run
measurement with a term specification is performed.
• BUSY LED
Turns on each time the measured data is updated.
IMPORTANT Laser safety
For safety, the laser will not turn on until 5 seconds after the power is turned on. If
the power is unintentionally turned on, turn off the power within 5 seconds to secure
the laser.
