5 - 3
No. 99MBC071A
5. MEASUREMENT MODE
• The setting procedure is as follows:
PROG
Step 1: Press the key in the ready state to enter the
setup mode.
Step 2: Each time the key is pressed, the setup guidance for each setup item changes
in the following order: ( → ) →
( ) → ( → ) → → ( → • • • or →
→ ) → ( ) → → ( ) → ( → ). Press the
ENT
key when the desired setup option is flashing. Press the key to reverse
this order.
Step 3: Modify the setup data. The method used to enter data is the same as that used in the
function setup mode.
For practice, modify the offset value from 12.5 mm to 12.34567 mm.
The previously set data is displayed and its least significant digit is flashing.
Enter “12.34567”.
PROG
7
56.3
4
12
PROG
(In single measurement)
Step 4: Press the
ENT
key to initiate the following
operation flow: Measure a reference gage, execute
the compensation calculation, save the setup data
in memory, then return to the ready state.
If the insertion of a comma after the thousandth
digit has been specified in the basic setup, the
comma will be automatically inserted.
PROG
(In simultaneous measurement)
For a single measurement the most recent setup
item will always be displayed in the upper section
of the display unit. However, the upper section of
the display unit shows a background measurement
in the simultaneous measurement.
TIP 1. In simultaneous measurement the upper section of the display unit shows a
background measurement. However, the setup mode for the foreground program
can be entered by pressing the key.
2. In single measurement, if an important setup item being displayed in the upper
section of the display unit is retained, confirmation of the measuring object and
modification of the setup data is easy.
3. If the
SET
key is pressed halfway in the setup operation, the operation is sus-
pended and the ready state is restored. This can be used to confirm the setup
data.
4. The last setup item made will be displayed first.
