No. 99MBC071A
vi
3.3 Outline of the Display Contents .................................................................. 3-22
3.3.1 Display unit ..................................................................................... 3-22
3.3.2 Data display unit ............................................................................. 3-22
3.4 Outline of Key Operations .......................................................................... 3-24
3.4.1 Description of key functions ........................................................... 3-25
3.4.2 Example key operations ................................................................. 3-29
4. SETTING UP THE MEASURING CONDITIONS ................................................. 4-1
4.1 Basic Setup ................................................................................................... 4-1
4.1.1 Outline of the basic setup procedure ............................................... 4-2
4.1.2 Description of each mode................................................................. 4-3
4.1.2.1 Selecting and setting the function in the B0 mode. ............... 4-4
a. Setting the resolution (Guidance: RES) ............................ 4-4
b. Setting the number of blank-out digits (Guidance: BLN) .. 4-5
c. Putting a comma after the thousandths digits
(Guidance: (,)) ................................................................... 4-5
d. Setting the buzzer function (Guidance: BUZZER) ............ 4-6
e. Setting the display latch timer (Guidance: LATCH) .......... 4-6
4.1.2.2 Selecting and setting the function in the B1 mode. ............... 4-7
a. Setting the output function in the ready state
(Guidance: D.OUT)............................................................ 4-7
b. Setting the analog output voltage if Err-0 occurs
(Guidance: ERR-0 V) ........................................................ 4-7
c. Selecting the display message if Err-0 occurs
(Guidance: ERR-0 D) ........................................................ 4-7
d. Selecting the display message at the start of measurement
(Guidance: RUN D) ........................................................... 4-8
e. Selecting the averaging method (Guidance: AVG.M)....... 4-8
f. Setting the GO/NG judgment method
(Guidance: JDG.M)............................................................ 4-8
g. Setting whether the target value is copied to the
reference value (Guidance: COPY) .................................. 4-9
4.1.2.3 Selecting and setting the function in the B2 mode .............. 4-10
a. Setting the workpiece type (Guidance: WORK.P) .......... 4-10
b. Setting the simultaneous measurement
(Guidance: PROG) .......................................................... 4-10
c. Selecting the method of specifying segments
(Guidance: SEG) ............................................................. 4-11
4.1.2.4 Selecting and setting the function in the B3 mode .............. 4-12
a. Setting the abnormal value elimination function
(Guidance: ADE) ............................................................. 4-12
b. Setting the automatic workpiece detecting function
(Guidance: AWDT) .......................................................... 4-12
c. Setting the number of scans (Guidance: SCAN) ............ 4-12
d. Setting the group judgment (Guidance: GTJ) ................. 4-13
e. Setting the group judgment output (Guidance: GTJ D) .. 4-13
