9 - 4
No. 99MBC071A
Mode No. Setup item Setup contents Default setup
B3 a. Abnormal value elimination
( )
b. Automatic workpiece detection
( )
B4 a. RS-232C port
( )
b. Baud rate ( )
c. Data bits ( )
d. Parity check ( )
e. Delimiter ( )
f. line control ( )
a. I/O RUN input ( )
b. I/O OFFS input ( )
c. I/O GO output ( )
a. Use of DCU ( )
d. Group judgment ( )
: Does not use /
: Use.
: Does not use.
: Diameter detection / : Position detection
c: Number of scans
: 16 times / : 1 time
: Uses for communication with PC
: Uses as a printer port (GP-IB is also available)
: Does not use. (GP-IB is also available)
/ / /
/
: 8 bits/ : 7 bits
: Does not use. : Odd parity
: Even parity
: CR + LF / : CR / : LF
: Does not use. : Uses.
: Triggers single-run measurement
: Triggers continuous-run measurement with term specification
: Triggers continuous-run measurement
: Enables offset function.
: Enables HOLD function.
: GO output/ : STB output
: ACK output
: Does not use. : Uses.
e. Setting the group judgment result output ( )
: Does not output. : Outputs.
: Does not use. : Uses only OUTPUT-1.
: Uses both OUTPUT-1 and OUTPUT-2.
B5
B6
9.2.2 List of calibration functions
Mode No.
Setup item Setup range Default setting
: HIGH CAL gage =
=
: LOW CAL gage
HIGH CAL
LOW CAL
Setup contents
Max.7 digits in the
positive direction only.
Max.7 digits in the
positive direction only.
Cancel (0)
Free (0)
CAL
9.2.3 Reading in the amount of light
Mode No. Setup range Default setting
: Automatically performs light amount detection.
: Reading in the light amount.
Setup contents
—Light amount detection
