4 - 24
No. 99MBC071A
Function No. Setup contents
F7 Setting automatic workpiece detection
In the basic setup mode either detection by dimension or detection by position can be selected.
If “Not performing the automatic workpiece detection” is selected, the setup guidance for the following
option will not be displayed.
Number of measurements: (0 to 999) → Invalidation period: (0 to 9999)
→ Detection lower limit: → Detection upper limit:
• Settings following the circle are factory settings.
Settings following a dot are ones which have been selected in the basic setup.
• Settings with no marking can be made in only one way.
NOTE 1: Measurement interval and the number of samples are automatically matched in simultaneous measurement.
NOTE 2: The function number may not be displayed depending on the basic setup contents.
F8 Setting the group judgment
In the basic setup mode setups for the group judgment can be made. If “Not performing the group
judgment” is selected, the setup guidance for the following option will not be displayed.
Group size : (0 ~ 99) → Statistical item:
(Average: / Maximum value: / Minimum value: / Range: )
Group lower limit value: → Group upper limit value:
Note2
Note2
