4 - 17
No. 99MBC071A
4. SETTING UP THE MEASURING CONDITIONS
c. Setting the GO output function from the I/O interface (Guidance: )
Set whether the GO output from the Analog I/O Interface is used as GO, STB (strobe), or
ACK (acknowledgment). This selection does not apply to the Second Analog I/O Inter-
face, since it has its specific output port. For information about each signal, refer to
Section 6.1.1, “I/O Analog Interface”.
: Used as a GO output.
: Used as a STB output.
: Used as an ACK output.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While the desired setup
option is flashing, press the
ENT
key. The
operation automatically proceeds to B6: Setting
the use of DCU.
NOTE If the Second Analog I/O Interface Unit is used
The Second Analog I/O Interface Unit, if installed, will also perform the function of
the standard analog I/O interface unit except the analog output through the I/O port.
4.1.2.7 Selecting and setting the function in the B6 mode
a. Setting the use of DCU (Guidance: )
Set whether to use the Mitutoyo DP-series Data Processing Unit called DCU (Digimatic
Output Unit).
The setup guidance for this option will be displayed only if the dedicated interface has
been installed.
: Does not use DCU.
: Only uses the OUTPUT-1 interface from the two interface units.
: Uses both interface units.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While the
desired setup option is flashing, press the
ENT
key. The operation automatically returns to B0:
Setting the resolution.
NOTE About the setting of a DCU
If is specified so two interfaces are used for single measurement, the
OUTPUT-2 will be ignored.
