4 - 10
No. 99MBC071A
4.1.2.3 Selecting and setting the function in the B2 mode
a. Setting the workpiece type (Guidance: )
Set whether the workpiece is an opaque object or transparent object.
: Workpiece is an opaque object.
: Workpiece is a transparent object.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
automatically proceeds to the setting of simulta-
neous measurement.
TIP If is selected for the workpiece type, the guidance for the selection of the
segment specification method is not displayed. It is omitted (the segment specifica-
tion process is entered directly).
b. Setting the simultaneous measurement (Guidance: )
Set whether to perform simultaneous measurement.
: Does not perform simultaneous measurement. (performs single measure-
ment)
: Performs simultaneous measurement.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
While the desired setup option is
flashing, press the
ENT
key. Operation automati-
cally proceeds to setting the method of specifying
segments.
TIP If (simultaneous measurement) is selected
If simultaneous measurement is selected, the setup guidance for the following will
not be displayed: Selecting the averaging method, segment specification, and setting
the group judgment.
