4 - 16
No. 99MBC071A
4.1.2.6 Selecting and setting the function in the B5 mode
a. Setting the RUN input function from the I/O interface (Guidance: )
Set if the RUN input from the I/O interface is used to trigger single-run measurement,
continuous-run measurement with a term specification, or continuous-run measurement. If
the function is used for triggering continuous-run measurement with a term specification,
RUN input from the Second Analog I/O Interface will also be used for triggering the same
kind of measurement.
: Used to trigger single-run measurement.
: Used to trigger continuous-run measurement with a term specification
: Used to trigger continuous-run measurement.
(Default setting:
)
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While
the desired setup option is flashing, press the
ENT
key. The operation automatically enters the
process for setting the OFFS input function from
the Analog I/O Interface.
b. Setting the OFFS input function from the I/O interface (Guidance: )
Set whether the OFFS input from the Analog I/O Interface is used for enabling the offset
function or holding the displayed value (while this signal is on, neither the GO/NG
judgment result nor the analog output value is updated). If the function for holding the
displayed value is selected, SHIFT + RUN input from the Second Analog Interface is also
treated as being the same function.
: Uses the input signal to enable the offset function.
: Uses the input signal to hold the value.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
proceeds to B6: Setting the use of DCU if the
Second Analog I/O interface is installed. Other-
wise the operation proceeds to the Setting the GO
output function from the I/O interface.
