4 - 8
No. 99MBC071A
d. Selecting the display message at the start of measurement (Guidance: )
Set the message to be displayed at the start of a single-run measurement or continuous-run
measurement.
: Displays “ ”.
: Continuously displays the previous data.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
automatically proceeds to the selection of the
averaging method.
e. Selecting the averaging method (Guidance: )
Select one of the following averaging methods: arithmetical average and moving average.
: Arithmetical average
: Moving average
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
automatically proceeds to the selection of the GO/
NG judgment method.
f. Setting the GO/NG judgment method (Guidance: )
Select one of the following GO/NG judgment methods: (lower limit value and upper limit
value), (multi-limit selection: 7 stages), and (target value + tolerance).
: GO/NG judgment is performed according to the specified lower limit and
upper limit.
: GO/NG judgment is performed according to the multi-limit selection (7
stages).
: GO/NG judgment is performed according to the specified target value and
tolerance.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While
the desired setup option is flashing, press the
ENT
key. If is selected, operation
proceeds to setting whether the target value is
copied to the reference value. If is not
selected, operation proceeds to B2: Setting the
workpiece type.
