4 - 26
No. 99MBC071A
4.5.3 Function setup mode
PROG
• If the function setup mode is entered using the
SET
key in the ready state, the function setup number
will be flashing as shown in the figure at the right.
• Each time the
key is pressed when the function
setup number is flashing, it will change as follows:
→ → → → → → → → →
. Press the
ENT
( ) key while the desired
function setup number is flashing to enter the setup
mode. If the
key is pressed, this order will be
reversed.
• If a key other than the
, , ,
ENT
,
SET
,
SHIFT
and
READ
keys are
pressed during the selection of a function setup number, an operation error will result.
• If each piece of setup data is accepted with the
ENT
key in the corresponding setup
mode, the operation will automatically proceed to the next setup item.
4.5.3.1 F0: Setting the segment
Use this function to set the measurement position (segment). The segment specification and
edge specification methods are provided for this purpose. Both can be selected in the basic
setup.
If this setup mode is entered, the previously established data will flash.
7654321
PROG
Segment
1) Segment specification
Places for displaying the segment numbers are fixed as
shown in the figure at the right. In this example, set to
SEG2.
PROG
Step 1: If the segment setup mode is entered, the previ-
ously established data will be displayed.
PROG
2
Press the
2
key.
PROG
ENT
Step 2: Press the
ENT
key to save the setup data
in memory.
Operation automatically proceeds to the
measurement interval setting.
TIP Segment setup example
PROG
2
4
1. Set to segments (2 + 4).
PROG
1
5
2. Set to segments (1 + 5).
