4 - 15
No. 99MBC071A
4. SETTING UP THE MEASURING CONDITIONS
d. Setting the RS-232C communication parity bit (Guidance: )
Set the parity check method for RS-232C communication.
: Does not use parity check.
: Uses odd parity.
: Uses even parity.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While the
desired setup option is flashing, press the
ENT
key. The operation automatically enters the
process for setting the delimiter for RS-232C
communication .
e. Setting the delimiter for communication (Guidance )
Set the delimiter (termination code of one sentence) for RS-232C communication.
: Uses CR+LF as the delimiter.
: Uses CR code as the delimiter.
: Uses LF code as the delimiter.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While the desired
setup option is flashing, press the
ENT
key. The
operation automatically enters the process for
setting the control method of the RS-232C
communication flow.
f. Setting the RS-232C line control (Guidance: )
Set the method of controlling the RS-232C communication flow.
: Does not use a particular control signal (using 3-wire teletype control).
: Uses a control signal.
(Default setting: )
Note: If the RS-232C interface is set as the printer port, line control will be
achieved by BUSY signals even if this option was set to .
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and .
While the desired setup option is flashing, press
the
ENT
key. The operation automatically
proceeds to B5: Setting the RUN input function
from the I/O interface.
