6 - 32
No. 99MBC071A
NOTE 1. Decimal Point Position
The decimal point position will be adjusted as follows for the DP series data
processor, which handles 6-digit data.
• If the uppermost (7th) digit of the output data is 0, the lower six digits will be
output.
• If the uppermost (7th) digit of the output data is not 0, the upper six digits will
be output.
• If six digits are in the decimal places, a “0” is output as a decimal point position.
Example)
yalpsiD
tuptuoedoccitamigiD
ataddettimsnarTnoitisoptnioplamiceD
1234.51234504
1234.561234564
1234.5672345673
123456.01234560
123456.72345675
• When the decimal point position of the input data is changed, the DP series
data processor cannot continue the data processing unless the accumulated
data is cleared. (Therefore, consider the measuring range of the LSM so that
the resulting data has a uniform decimal point position.)
2. Data output at simultaneous measurement
If two Digimatic Output Units are used in simultaneous measurement, outputs to
each Digimatic Output Units are as follows:
• OUTPUT-1: Data from program Nos. 0 through 4
• OUTPUT-2: Data from program Nos. 5 through 9
If a single Digimatic Output Unit is used, it must be connected to OUTPUT-1,
through which data of the foreground program is outputted.
