Filter
Top Products
15 - 4
Back Panel
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into one of the two Ethernet ports provided. The second RJ45
Ethernet port can be used for connection to an additional device such as a printer, workstation,
eBase, or another Net Base.
Note: The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports are
used, do not connect both Net Base interfaces to the same layer 2 LAN.
Each Ethernet port has a dedicated green and yellow status LED.
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices
and/or the Internet. For more information, see Establishing Ethernet Communication on page 15-6.
DC Power Jack
This connector receives input from the power adapter. Plug the power connector cable from
the power adapter into this connector, see Power.
Status Yellow LED Green LED
No Ethernet Link Off Off
10Mbps Ethernet Connection Established Off On
100Mbps Ethernet Connection Established On On
Data transfer in progress Connection Speed Dependent
(see above)
Flashing
DC Power
Jack
Port 2: 10/100Mbps RJ45 Ethernet Port
Yellow LED (Qty. 1 Per Port)
Green LED (Qty. 1 Per Port)
Port 1: 10/100Mbps RJ45 Ethernet Port