Filter
Top Products
102 Section 2I. Experiencing Multimedia
ⅷ Image Properties. This option lets you adjust the capture properties, such as Contrast, Saturation, and
Sharpness.
ⅷ Effect. Choose a special effect such as Grayscale or Sepia to apply to your photos or video clips.
ⅷ Metering Mode. Select a metering mode to allow the camera to measure the amount of light and calculate
the best-fit exposure value before capturing. Choose either
Center Area to measure light using the center
area of the subject, or
Average to measure light using the area around the subject.
ⅷ Prefix. When Default is selected as the prefix, the file name of each new captured file is set to “IMAGE” or
“VIDEO” followed by a sequential number, for example: IMAGE_001.jpg. You may also choose to name
files using either the current
Date or Date & Time as the prefix.
ⅷ Counter. To reset the file naming counter back to 1, tap Reset.
ⅷ Flicker Adjustment. When taking indoor shots, flicker on the camera screen may be caused by
inconsistencies between the vertical scan rate of the camera display and the flicker frequency of
fluorescent lighting. To reduce flicker, you can change the flicker adjustment setting to the proper
frequency (
50Hz or 60Hz) of the power in the country where your device is being used (60Hz throughout
the United States).
1. Tap a setting to adjust.
2. Tap
OK to save the settings.
3. Tap or , or press the Navigation Control right or left (landscape orientation) to increase or
decrease the value.
4. Tap
Cancel to close the submenu without applying and saving the changes.
5. Tap the
Reset icon to reset all properties to their default values.
Note
If you set the camera to save captured photos to a microSD card, the prefix cannot be selected. Captured
photos will be named using the convention
IMAGnnnn.jpg (where ‘nnnn’ is the counter) which is the
DCIM (Digital Camera Images) naming standard, and will be saved to the \DCIM\100MEDIA folder on the
microSD card.
1
32
5
4