Filter
Top Products
200 Section 4B. Regulatory Notices
Section 4B
Regulatory Notices
ࡗ Regulatory Agency Identifications (page 200)
ࡗ Federal Communication Commission Interference Statement (page 200)
ࡗ Industry Canada Statement (page 201)
ࡗ FCC Hearing-Aid Compatibility (HAC) Regulations for Wireless Devices (page 201)
ࡗ SAR Information (page 202)
ࡗ IC Statement (page 203)
ࡗ Telecommunications & Internet Association (TIA) Safety Information (page 203)
ࡗ WEEE Notice (page 204)
ࡗ RoHS Compliance (page 204)
This section provides more safety information and regulation statement for using your device.
Regulatory Agency Identifications
For regulatory identification purposes, your product is assigned a model number of RAPH800.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with
your
RAPH800.
The Battery Pack has been assigned a model number of
DIAM171.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
ⅷ Reorient or relocate the receiving antenna.
ⅷ Increase the separation between the equipment and receiver.
ⅷ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ⅷ Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Note
This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp
power supply unit.