Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting fast LACPDUs
A - Device is in active mode P - Device is in passive mode
Port Flags Pri AdminKey OperKey State Num Status
---- ----- ---- -------- -------- ----- ---- -------
FE 1/1 SA 1 0x1 0x1 0x45 0x2 DOWN
FE 1/2 SA 1 0x1 0x1 0x45 0x3 UP
In the WebUI
Access LACP from the Configuration->Network->Port tabs. Use the drop down menus to enter the LACP values.
l LACP Group—The link aggregation group (LAG) number; range is 0 to 7
l Mode—Active negotiation state or not in an active negotiation state indicated by the
passive
option.
l Priority—The port priority value; range is 1 to 65535 Default 255
l Timeout—Time out value for the LACP session; Long, the default, is 90 seconds; short is 3 seconds
LACP Sample Configuration
The following sample configuration is for FastEthernet (FE) port/slot 1/0, 1/1, and 1/2
interface fastethernet 1/0
description "FE1/0"
trusted vlan 1-4094
lacp group 0 mode active
!
interface fastethernet 1/1
description "FE1/1"
trusted vlan 1-4094
lacp timeout short
DellPowerConnectW-SeriesArubaOS6.2 | User Guide | 150
