67 |The BasicUser-CentricNetworks DellPowerConnectW-SeriesArubaOS6.2 | User Guide
4. Configure the SSID(s) with VLAN 1 as the assigned VLAN for all users.
Deployment Scenario #2: APs All on One Subnet Different from Controller Subnet
Figure 5: APs All on One Subnet Different from Controller Subnets
In this deployment scenario, the APs and the controller are on different subnetworks and the APs are on multiple
subnetworks. The controller acts as a router for the wireless subnetworks (the controller is the default gateway for the
wireless clients). The uplink port on the controller is connected to a layer-2 switch or router; this port is an access
port in VLAN 1.
For this scenario, you must perform the following tasks:
1. Run the initial setup wizard.
l Set the IP address for VLAN 1.
l Set the default gateway to the IP address of the interface of the upstream router to which you will connect
the controller.
2. Connect the uplink port on the controller to the switch or router interface.
3. Deploy APs. The APs will use DNS or DHCP to locate the controller.
4. Configure VLANs for the wireless subnetworks on the controller.
5. Configure SSIDs with the VLANs assigned for each wireless subnetwork.
