Dell 6.2 Manual

A SERVICE OF

next previous

438 | AccessPoints(APs) DellPowerConnectW-SeriesArubaOS6.2 | User Guide

Command Description

setenv master <ipaddr>

IP address of the AP’s master controller.

setenv serverip <ipaddr>

IP address of the TFTP server from which the AP can download its boot image.

setenv dnsip <ipaddr>

IP address of the DNS server used by the AP.

setenv domainname

<domain>

Domain name used by the AP.

5. When you are finished, type Save and then press Enter to save your settings.

NOTE: Other AP console commands may be available when accessing an AP directly through its console port, but these commands

can cause configuration errors if used improperly and should only be issued under the direct supervision of Dell technical support.

The example below configures an AP location and domain name using an AP console connection:

To view current AP settings using the AP console, issue the command printenv <name> where <name> is one of

the variable names listed in Table 125, such as ipaddr, dnsip or gatewayip.