Filter
Top Products
NDA-24305 CHAPTER 5
Page 91
Revision 1.0
INDIALING THROUGH MAIN-PRI
STEP 5: ARTD - Assign Tie Line route data and the dummy route data.
For Dummy RT, CDN 6 (TCL)=4, CDN 7 (L/T)=1 and CDN 13 (AC)=1 are necessary.
STEP 6: ATRK - Assign the LENS data of each trunk.
STEP 7: MBTK - Make idle the trunks.
STEP 8: AFRS - Assign NPC (Number Pattern Code) and OPR (Outgoing Route selection pattern Number)
to the dummy route.
STEP 9: AOPR - Make the route selection data using the parameter OPR, SKIP, etc.
STEP 10: ARSC - Allow the route restriction for each trunk.
For Dummy RT, the data assignment of only RRI3 is necessary.
STEP 11: ARRC - Release the tandem connection restriction between the Main Office and the satellite office.
Note:
When the satellite office is connected to Main office via CCIS No.7, assign CDN98 (CI)=1 of the ARTD
command to the speech route of CCIS No.7 link. (Refer to [T-44] Transfer Message (TRM))