Filter
Top Products
CHAPTER 4 NDA-24305
Page 18
Revision 1.0
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
2. COMMANDS
2.1 ASYD: ASSIGNMENT OF SYSTEM DATA
SYSTEM
DATA
TYPE
(SYS)
SYSTEM
DATA
INDEX
(INDEX)
0-511
DATA
(DATA)
00-FF
(Hex)
BIT CORRE-
SPONDING
DATA
SYSTEM DATA CONTENTS
DATA
0/1
BIT
1
76
0b
0
Not used Table Development:
Common or Separate
Day/Night Data Tables.
Note:
When data
tables are
designated as
“Common”,
the Day mode
designation
must be used
in the
respective
commands.
b
1
Same Number Special Access Code
Data (ASPS command)
0/1 = Common/Separate
b
2
Call Forwarding Service by Calling
Number Data (AFCP command)
0/1 = Common/Separate
0b
3
Not used
0b
4
0b
5
0b
6
0b
7
186
b
0
0/1 = Link Re-Connection Not Involved/Link Re-Connection
Involved
Note:
An Interoffice transfer service is available. For example,
with No. 7 CCIS, a caller has called outside their own
office but is actually talking with somebody in their own
office. This bit is used to reconfigure links so they are not
wasted in call transfer service.
b
1
Restriction check based on the caller’s restriction class when the
outgoing trunk is using the No. 7 CCIS in a tandem connection.
0/1 = No Check/Check
0b
2
0/1 = -/No. 7 CCIS Loop-Back Test in progress
0b
3
Not used
b
4
Serial Call-Loop Release:
0/1 = Out (CCSA key)/In Service (No CCSA key)
b
5
Clearing of the buffer memory for use in the centralized
management report (For CCIS).
0/1 = not necessary/necessary
b
6
CCIS or ISDN:
0/1 = Out/In Service
b
7
Centralized IC Billing Office Code:
0/1 = Ineffective/Effective
187 00 Data Bus used for CCIS/ISDN cards (Assign 00 Hex)