Filter
Top Products
NDA-24305 CHAPTER 6
Page 211
Revision 1.0
CALLING PARTY INFORMATION TRANSFER/TRANSFER MESSAGE (TRM)
3. Programming
STEP 1: Assign the Basic Data for ISDN.
STEP 2: ASYD - Assign the following system data for CCIS
Note
SYS-1 Index 4, b4: Temporary Class Conversion
0/1=Not Required/Required. (always assign “1”)
Index 82, b4-b7: Station Number Display Pattern on the ATTCON
Index 180&181: Originating Point Code
Index 182&183: Centralized Billing Point Code
Index 184&185: Centralized Management Report Point Code
Index 186: Service Check
Index 187: Number of CCH/DCH cards
(always assign 00 Hex)
Index 188, b0: No. 7 CCIS Control System Interoffice Audit Test
0/1=Not Required/Required.
Index 189, b4-b7 ACM, UBM Signal “No-Receiving” Timer (Normally assign
F0 Hex.)
Note:
ISDN transmitting information service is necessary for the transparency of ISDN information between
ISDN and CCIS No. 7 network.
STEP 3: ARTD - Assign the following route class data for CCIS Trunk
(Signal Channel & Speech Channel)
STEP 4: ARTD - Assign a following data to the speech route of CCIS No. 7.
CDN98 (CI) ISDN transmitting information.
0= Out of service
→ 1= 16-Digit Caller Number Service, Attribute Information Notification service,
and Calling Sub-Address Transfer Service.
2-15= Not used.
Assign data “1” in this CDN.
ROUTE FOR SIGNAL CHANNEL ROUTE FOR SPEECH CHANNEL
• OSGS = 0
• ONSG = 2
• ISGS = 0
• INSG = 2
• TCL = 4
• L/T = 1
• RLP = 2
• LSG = 13
• ANS = 0
• PAD = 7
• BT = 0
• DPLY = 0
• LYER1 = 0
• NET = 0
• INT = 0
• OSGS = 0
• ONSG = 2
• ISGS = 0
• INSG = 2
• TCL = 4
• L/T = 1
• RLP = 2
• LSG = 12
• ANS = 1
• PAD = 4
• BT = 1
• DPLY = 1
• LYER1 = 0
• NET = 0
• INT = 0