Filter
Top Products
NDA-24305 CHAPTER 5
Page 107
Revision 1.0
LDN NIGHT CONNECTION-OUTSIDE-PRI
L-46 LDN NIGHT CONNECTION-OUTSIDE-PRI
1. General Description
This feature routes Listed Directory Number (LDN) calls from both ISDN/non-ISDN network to a preselected
station outside the system when the system is in Night mode.
2. Operating Procedure
To answer LDN NIGHT CONNECTION calls:
1. An incoming LDN call in Night mode is automatically routed to a preselected LDN NIGHT
CONNECTION station outside the system.
2. The calling party receives Ringback Tone.
3. The call is sent out to the outside station.
4. The outside station answer the call.
3. Programming
STEP 1: ALDN - Assign LDN number and its transfer destination.
TN: Tenant Number
LDN: Listed Directory Number (must match station numbering plan)
Night Transfer: Y/N
If no, then LDN will only go to Attendant.
If yes, then the following parameters will be enabled:
TYPE: Night Transfer Type
1: Station number
2: Outside (up to 8 digits)
3: ADC (when more than 8 digits are required)
STN: For Types 1&2.
For type 2, assign access code and outside number here.
(A CCIS remote office station number can be input here also).
ADC: For Type 3.
Input ADC number desired as assigned in ASPD command.
STEP 2: ASPD - Assign an access code and outside number to an ADC (000-999). This step is required only
if access code and outside number are greater than eight digits.
STEP 3: ACFR - Assign TESFI:2 (Night Connection-Fixed) to be allowed CCI:1(LDN). This allows LDN
to go to Night transfer destination.
STEP 4: ARRC - The incoming route of the LDN must allow trunk-to-trunk connection to the outgoing
destination route and to the LCR dummy route: ARI: D. (Direct Connection.)