Filter
Top Products
CHAPTER 5 NDA-24305
Page 100
Revision 1.0
LCR-ATTENDANT MANUAL OVERRIDE-PRI
L-33 LCR-ATTENDANT MANUAL OVERRIDE-PRI
1. General Description
This service feature provides an ATTENDANT CONSOLE [A-3] to override the LCR-TIME OF DAY
ROUTING-PRI [L-32] pattern and then an alternate routing pattern group will be selected.
2. Operating Procedure
To set LCR-ATTENDANT MANUAL OVERRIDE-PRI:
1. Press an idle “LOOP” key.
2. Dial the LCR-ATTENDANT MANUAL OVERRIDE-PRI access code; receive Special Dial Tone.
3. Dial the LCR-TIME OF DAY ROUTING-PRI [L-40] pattern number (1 to 7)
Note 1
; receive Service Set
Tone.
4. Press the “RELEASE” key.
To cancel LCR-ATTENDANT MANUAL OVERRIDE-PRI:
1. Press an idle “LOOP” key.
2. Dial the LCR-ATTENDANT MANUAL OVERRIDE-PRI access code; receive Special Dial Tone. The
display of the LCR-TIME OF DAY ROUTING-PRI [L-32] pattern number is shown.
3. Dial 0 to cancel; receive Service Set Tone.
4. Press the “RELEASE” key.
Note 1:
TDPTN of the AOPR/PTN of the ATCP command.
Note 2:
During this operation, the following is displayed on the display of the ATTCON.
3. Programming
STEP 1: Assign the Basic Data for ISDN. (Refer to Chapter 3, “Basic Data Assignment for ISDN”.)
STEP 2: ANPD - Reserve a number level for an access code for this service.
STEP 3: ASPA - Assign Access Code, CI=N (Normal), SRV=SSC and SID=60
STEP 4: ATCP - Assign the Time of Day Pattern data.
3
KIND PTN
KIND: 3 is displayed in this service.
PTN: 0=Cancel
1-7=PTN