Filter
Top Products
CHAPTER 6 NDA-24305
Page 168
Revision 1.0
SUPPLEMENTARY SERVICE
STEP 4: ADPC - Assign PC (Point Code) to Bch route and Dch route. (Refer to the following example)
RT=10 (Bch) PC=10
RT=11 (Bch) PC=10
RT=12 (Dch) PC=10
STEP 5: ACSC - Assign the location of DCH (Dch handler) and Bch. (Refer to the following example)
STEP 6: ACIC1 - Assign CSCG corresponding to PC (Point Code). (Refer to the following example)
PC=10 CSCG=130
STEP 7: ATRK - Assign the Trunk data for Dch.
STEP 8: ARTI - Assign the Trunk Application data .
Note
If the H11 terminal does not provide the initial setup procedure conforming to Q931
protocol, assign the following data.
CDN 2 (RST)=3 Assignment of Restart
0: Restart Send per Individual Channel
1: –
2: –
3: Restart not Send
Note:
Circuit Card must be initialized after this assignment.
Dch (ILCG)
Bch (ILCG)
PIM0
I
L
C
G
24
P
R
T
Group
No.
03 05 07
02 04 06
Bch (PRT)
Bch (ILCG)
CSCG CICG DCH/CCH
CSCG=130 0 00002
1 00002
2 00002
3 00002
4 00002
5 00002
6 00002
7 00002
CSCG=131 0 00003
1 00004
2 00003
3 00003
4 00003
5 00003
6 00003
7 00003