Filter
Top Products
NDA-24305 CHAPTER 3
Page 15
Revision 1.0
BASIC DATA ASSIGNMENT FOR ISDN
3. CALLING NUMBER PATTERN DATA (CNP) ASSIGNMENT
Calling party number can be transmitted included in the ISDN messages through ISDN network. This function
provides the PBX user with a variety of ISDN services. This section describes some conditions for programming
data related with this function when interworking with the Fusion link as shown Figure 3-3.
Figure 3-3 Calling Number When Interworking with FCCS Link
(1) This data should be assigned at NCN.
(2) Calling Number Pattern (CNP) for the outgoing call (CALLING PARTY RECOGNITION) and that for the
incoming call (SID TO NETWORK-PRESENT) should be separated.
(3) The services to be related with this feature are shown below.
• CALL PARTY RECOGNITION SERVICE (DIRECT-IN-TERMINATION)
• CALL PARTY RECOGNITION SERVICE (CALL FORWARDING-ALL CALLS/BUSY LINE/
DON’T ANSWER)
• SID TO NETWORK-PRESENT/SID TO NETWORK-PRIVACY
PROGRAMMING
ACNPN and ACNDN command must be used in pairs. The use of other pairs, for example ACNP and ACNDN,
is not recommended.
(1) Originating from the non-ISDN terminal
STEP 1: ACNPN - Apply the Calling Number Pattern number to the logical route to be provided SID to
Network-Present.
OG/IC=O (Outgoing Call; SID to Network-Present)
LGRT=the route used for SID to Network -Present
CNP=Calling Number Pattern (1~1023)
* The detail for the pattern is programmed with the ACNDN command.
ISDN
network
RT=6, LGRT=16
RT=3, LGRT=13
Station B (610000)
DID no. : 0297-74-1234
Station A (600000)
DID no. : 0471-81-1969
Node B
Node A
network
ISDN
FCCS
Destination's
number
03-3454-1111
Calling party number
Note
0471-81-1969
Example)
.
Note:
Since Station A originates a call via the ISDN line established in Node A in this example, the calling
party number to be received by the destination station is the DID No. programmed at Node A.