Filter
Top Products
CHAPTER 5 NDA-24305
Page 54
Revision 1.0
CALL FORWARDING-INTERCEPT/ANNOUNCEMENT-PRI
C-101 CALL FORWARDING-INTERCEPT/ANNOUNCEMENT-PRI
1. General Description
This feature provides for the interception of a called party number received via ISDN by DIRECT INWARD
DIALING [D-8] calls which cannot be completed (unassigned station, level, etc.). These calls are automatically
routed to a recorded announcement, informing the caller that an inoperative number was reached and giving the
listed directory number for information.
This feature permits a station originated call, upon encountering a restricted outgoing number, to automatically
be routed to a recorded announcement informing the caller that the dialed number is restricted for this station.
This feature permits a station originated call, upon encountering a trunk busy condition, to automatically be
routed to a recorded announcement informing the caller that all the outgoing trunks are busy.
Note:
This feature requires an announcement trunk and an announcement machine or a Digital Announcement
Trunk (DAT).
2. Operating Procedure
No manual operation is required.
3. Programming
STEP 1: ACFO - Enable this feature by allowing CF = 3: CALL FORWARDING-INTERCEPT/
ANNOUNCEMENT. The CFI parameter will come up for assignment. An Attendant
Console may be programmed so that intercepted calls can terminate at the CALL
FORWARD INTERCEPT key. If no assignment is made, the PBX program goes to the
AAED command for announcement trunk information because the destination of the
transfer is a trunk and not a station or Attendant Console.
STEP 2: ARTD - Assign the announcement route (in the case of DAT) as shown below:
STEP 3: ATRK - Assign the LENs, Announcement Trunk Route Number, Trunk Number, and Tenant
Number.
STEP 4: MBTK - Assign the Make Idle status to the Announcement Trunk.
STEP 5: ARRC - If TIE Line or REMOTE ACCESS TO PBX [R-2] connection to the ANNOUNCEMENT
SERVICE Trunk is required, allow trunk-to-trunk connection using ARI: D, Direct
Connection.
RT: 1
1-OSGS : 2 2-ONSG : 2 6-TCL : 4 7-L/T : 1 15-LSG : 0*
*If a PA-8TL
The other data than above must be set “0” (default data).