Filter
Top Products
NDA-24305 CHAPTER 5
Page 149
Revision 1.0
SPEED CALLING OVERRIDE-SYSTEM-PRI
S-89 SPEED CALLING OVERRIDE-SYSTEM-PRI
1. General Description
This feature allows a station with restriction on outgoing ISDN and/or certain miscellaneous trunk calls by the
station CLASS OF SERVICE-INDIVIDUAL [C-15] to place such calls by using the prefixed digits
(abbreviated call code) registered beforehand in SPEED CALLING-SYSTEM-PRI [S-82]. A station may use
this feature if it has been assigned the appropriate SFC (Service Feature Class).
2. Operating Procedure
1. Lift the handset (includes “SPEAKER” key operation on D
term
). Listen for Dial Tone.
2. Dial the speed calling access code (one or two digits).
3. Dial the abbreviated call code (two or three digits).
4. If the station is allowed this call, the call is completed, if not, the station will hear Reorder Tone.
3. Programming
STEP 1: ASYD - System Data 2, Index 1, bit 6: Is SPEED CALLING OVERRIDE (on a SFC basis) to
be enabled? 0/1: No/Yes.
bit 7: Is SPEED CALLING OVERRIDE (on a system basis)
to be enable? 0/1 = No/Yes.
Note:
Assign the data “1” in either bit 6 or bit 7.
STEP 2: ANPD - Reserve a number level for feature access. Assign for Normal. Assign NND in accordance
with a predetermined numbering plan.
STEP 3: ASPA - Assigning an access code to SPEED CALLING-SYSTEM, assign SRV = SSC, SID = 15.
Program for Normal. NND = Access code plus ADC (Abbreviated Digit Code). See ASPD.
Example: 6 (ACC) + 010 (ADC)
1 digit + 3digits = NND = 4
STEP 4: ASFC - Assign a Service Feature Class that allows SFI 12 to stations that will have SPEED
CALLING-SYSTEM.
STEP 5: ASPD - Assign the Tenant Number, the Abbreviated Digit Code (ADC), and the CD-Telephone
Number to be sent. Include the access code of the route in the CD.
STEP 6: AABD - Assign the Tenant (TN); and the Abbreviated Speed Calling Code, (ADC); as assigned in
the ASPD command. Assign the Service Feature Class (SFC) and Restriction Data (RES).
RES 0: Connection is restricted.
RES 1: Connection is allowed.
Note:
This step can be skipped when System Data 2, Index 1, bit 6=0 in ASYD.
STEP 7: AKYD - Assign SPEED CALLING-SYSTEM to a programmable Line/Feature key. Assign KYI =
1 and FKI = 15.