Filter
Top Products
CHAPTER 6 NDA-24305
Page 234
Revision 1.0
EVENT BASED CCIS - Q-SIG TRANSPORT
• Station Controlled Conference – CCIS [S-56]
• Station-to-Station Calling – CCIS [S-57]
• Station-to-Station Calling – Operator Assistance – CCIS [S-58]
• Step Call – CCIS [S-59]
• Synchronous Data Switching – CCIS [S-60]
• Supervisory Call – CCIS [S-73]
• Toll Restriction – 3/6-Digit – CCIS [T-26]
• Trunk Answer from Any Station – CCIS [T-27]
• Uniform Numbering Plan – CCIS [U-5]
• Voice Call – CCIS [V-7]
Note:
When A/D=1 (Digital) is assigned by CDN45, ARTD, this feature is available.
4. Programming
STEP 1: Assign the Basic Data for ISDN. (Refer to Chapter 3.)
STEP 2: Assign CCIS No.7 related data.
Note:
Assign the LEN of the DCH for controlling E-CCIS route at the CCH parameter of the ACSC command.
STEP 3: ARTD - Assign the Bearer Capability for the speech channels of the E-CCIS line.
CDN45 A/D: 0/1= Analog (Bearer Capability: Speech)/Digital (Bearer Capability:
Unrestricted Digital)
CDN49 TRKS: 0/1= select the trunk in ascending order/descending order (CIC No. is
programmed by the ACSC command)