NEC NDA-24305 Cell Phone User Manual


 
CHAPTER 5 NDA-24305
Page 114
Revision 1.0
MULTIPLE CALL FORWARDING-ALL CALLS-PRI
M-75 MULTIPLE CALL FORWARDING-ALL CALLS-PRI
1. General Description
This feature permits a call from the ISDN network to a station set to CALL FORWARDING-ALL CALLS-PRI
[C-95] to be forwarded multiple times to a predesignated idle station.
2. Operating Procedure
To set CALL FORWARDING-ALL CALLS-PRI[C-95] from an individual station:
1. Lift the handset; receive Dial Tone.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI access code; receive Special Dial Tone.
3. Dial the desired target station number; receive Service Set Tone.
To cancel CALL FORWARDING-ALL CALLS-PRI[C-95] from an individual station:
1. Lift the handset; receive Dial Tone.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI cancel code; receive Service Set Tone.
To set CALL FORWARDING-ALL CALLS-PRI[C-95] from the ATTENDANT CONSOLE [A-3]:
1. Press an idle “LOOP” key.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI access code; receive Special Dial Tone.
3. Dial the TENANT [T-12] number (2 or 3 Digits).
4. Dial the originating station number.
5. Dial the desired target station number; receive Service Set Tone.
To cancel CALL FORWARDING-ALL CALLS-PRI[C-95] from the ATTENDANT CONSOLE [A-3]:
1. Press an idle “LOOP” key.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI cancel code; receive Special Dial tone.
3. Dial the TENANT [T-12] number (2 or 3 Digits).
4. Dial the originating station number; receive Service Set Tone.
3. Programming
STEP 1: ASYD - System Data 1, Index 4, bit 6: One burst of ringing at forwarding station when
MULTIPLE CALL FORWARDING-ALL CALLS is in
service?
0/1: No/Yes.
Index 69,bit 1: A burst of Ringback Tone to alert the person receiving a call
that this is a MULTIPLE CALL FORWARDING-ALL
CALLS call. In service? 0/1: No/Yes. Normally assigned
as data “0”.
System Data 2,Index 6,bit 4:Enable stations set for MULTIPLE CALL FORWARDING-
ALL CALLS be allowed to use their phones normally. If
data “0” is assigned, the station will only be able to call
the Attendant Console. Assign on a per-tenant basis.