Filter
Top Products
NDA-24305 CHAPTER 5
Page 41
Revision 1.0
CALL FORWARDING-ALL CALLS-PRI
3. Programming
STEP 1: ASYD - System Data 1, Index 4, bit 6: One burst of ringing at the forwarding station when CALL
FORWARDING-ALL CALLS is in service? 0/1: No/
Yes. (single-line station only)
Index 248, bit 7:Dial Tone to be sent out when a station on which CALL
FORWARDING-ALL CALLS is set, goes off-hook to
place and outgoing call 0/1: Dial Tone/Special Dial Tone.
Index 69, bit 1: A burst of Ringback Tone to alert the person receiving a
call that this is a CALL FORWARDING-ALL CALLS
call. In service? 0/1: No/Yes. Normally assigned as data
“0”.
bit 2: Send short tone when a recalled C.F.-All Calls call is
answered. 0/1: Not Required/Required.
System Data 2, Index 6, bit 4: Call Origination Restriction of a station upon setting
CALL FORWARDING-ALL CALLS.
0/1=Restricted/Allowed.
STEP 2: ANPD - Reserve a number level for feature access and cancel. Assign Connection Index, CI = N;
Normal. Assign NND in accordance with a predetermined numbering plan.
STEP 3: ASPA - Assign an access code to CALL FORWARDING-ALL CALLS entry SID = 8. And to
CALL FORWARDING-ALL CALLS cancel SID = 9. Assign Connection Status Index
(CI) for Normal service.
STEP 4: ASFC - Assign a Service Feature Class that allows SFI = 7 to the Class of stations which will
activate CALL FORWARDING-ALL CALLS.
STEP 5: AKYD - For D
term
sets, CALL FORWARDING-ALL CALLS may be assigned to a programmable
line/feature key. Assign KYI = 1 and FKY = 2.
STEP 6: ATNR - Allow tenant-to-tenant connection for Inter- and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this feature to be set by the Attendant Console, assign
Inter- and Intra-Tenant Connection TRI = 3, via the Attendant Console. Also allow TRI =
0, station-to-station calling.