Filter
Top Products
CHAPTER 5 NDA-24305
Page 132
Revision 1.0
PAGING TRANSFER-PRI
P-47 PAGING TRANSFER-PRI
1. General Description
This feature will allow a station user to transfer a paged call to a party that has been placed on hold.
2. Operating Procedure
While a station user is engaged in a C.O. line call:
1. The Station user presses the switchhook flash key; receives Special Dial Tone.
2. Station user dials the PAGING access code; receives continuous Ringback Tone for approximately one
second.
3. Station user pages the desired party.
Following two are the methods that the paged user answers:
1. Non-Delay System; On dialing the PAGING Answer access code, the party paged is immediately connected
to the PAGING station.
2. PAGING TRANSFER Supervision; The PAGING station user replaces the handset after the page. By
dialing the PAGING Answer access code, the paged party is directly connected to party on hold.
For Non-Delay Systems; when a PAGING station replaces the handset after talking with the paged party, the
held party is directly connected to the paged party.
3. Programming
STEP 1: ASYD - System Data 1, Index 73, bits 0&1: b1
b0
0 1 For MEET-ME PAGE. Non-Delay service.
1 0 For MEET-ME PAGE. Delay service.
1 1 For MEET-ME PAGE. Delay service with Call
Transfer.
bit 3: Are PAGE cancel codes provided for each route?
0/1: Per route/Common to all routes.
Index 74, bits 0&3: Assign the cancel timer for unanswered page.
Assign data 00H for 30 seconds.
(0-F+1)×30 = Cancel Timer.
System Data 2, Index 1, bits 0&1: Consultation Hold allowed or denied. 00: Denied;
01: Originating and Terminating Calls allowed;
Tandem Call Denied; 11: All calls allowed.