Filter
Top Products
NDA-24305 CHAPTER 6
Page 205
Revision 1.0
SID TO NETWORK - PRESENT/SID TO NETWORK - PRIVACY
S-91/S-92 SID TO NETWORK - PRESENT/SID TO NETWORK - PRIVACY
1. General Description
<SID TO NETWORK-PRESENT>
This feature allows SID (Station Identification Number) to be delivered to the ISDN when a call originates from
a terminal connected to the PBX.
<SID TO NETWORK-PRIVACY>
In addition, the originating station user may control the transfer of SID to the network via AUTHORIZATION
CODE dialing through the PBX.
2. Operating Procedure
1. Lift the handset and receive Dial Tone.
2. Dial an access code for “Authorization Code”. (For SID TO NETWORK-PRIVACY)
3. Dial “Authorization Code”. (For SID TO NETWORK-PRIVACY)
4. Dial an originating call number to ISDN.
Note:
Without dialing the authorization code, SID is sent to the destination.
3. Programming
STEP 1: Assign the Basic Data for ISDN. (Refer to Chapter 3.)
Note:
When two or more DID numbers are assigned to a station, the last DID number assigned will be delivered
to the ISDN as a Station Identification Number (SID). However, when the last DID number assigned has
been deleted [even if the other number(s) still exist], any DID number is not transferred to the network
(no SID is transferred to a destination). In this case, reassignment of the DID number(s) is necessary for
sending SID to the network.
STEP 2: ACNP - Assign the pattern number for Bch route.
OG/IC=O (Select “OG”)
RT=Bch Route number
CNP=Pattern Number
STEP 3: ACND - Assign the information for the pattern.
CNP=Pattern Number (Must be same pattern No. as one of ACNP).
SKIP=Skip digits of station number.
Note 1, Note 2
ADD=Number of additional digit (Pilot number)
DC=Pilot Number