Filter
Top Products
CHAPTER 6 NDA-24305
Page 284
Revision 1.0
IS-11572 (LAYER 3 SPECIFICATIONS FOR INTER-PBX SIGNALING PROTOCOL)
STEP 4: ARTI - Assign the trunk application data.
INTD = 1 (IS-11572)
STEP 5: ATRK - Assign Bch trunks. Note that the LEN of Dch trunk should be assigned after STEP 9:
ACIC2 command assignment.
STEP 6: MBTK - Make idle Bch trunks.
STEP 7: ADPC - Assign PC (Point Code) for both Bch and Dch at each physical interface.
Note:
Same PC (not existing PC for CCIS) must be assigned for both Bch and Dch.
STEP 8: ACSC - Assign the location of DCH (Dch Handler).
(Refer to the following example)
STEP 9: ACIC 1- Assign CSCG
PC=xxx CSCG=Even No. (130-254)
STEP 10: ACIC 2- Assign CIC No.
PC=xxx CIC(1~999) LENS (for speech channel)
STEP 11: ATRK - Assign the LEN of Dch trunk.
Note:
The following data is available if necessary.
ASFC - SFI 139: SID to Network - Privacy [COLR]
0 = –
1 = SID to Network - Privacy
PIM0
Group No.
04
05
06
07
PRT
CSCG=130 (Even No.) CICG No.= 0
1
2
3
4
5
6
7
CCH= 00004
00004
00004
00004
00004
00004
00004
00004
Note:
Bch location is not necessary. (DCH location only)
Attention: The circuit card must be initialized after changing data.