Filter
Top Products
236 :: regulatory information
FCC Statement This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Safety Exposure To Radio Frequency Energy (SAR) Radio
transmitting devices radiate Radio Frequency (RF) energy during its
operation. RF energy can be absorbed into the human body and
potentially can cause adverse health effects if excessive levels are
absorbed. The unit of measurement for human exposure to RF energy is
“Specific Absorption Rate” (SAR).
The Federal Communications Commission (FCC), Industrie Canada
(IC), and other agencies around the world have established limits that
incorporate a substantial safety margin designed to assure the safety of
all persons using this equipment.
In order to certify this unit for sale in the US, Canada and Europe this
unit has been tested for RF exposure compliance at a qualified test
laboratory and found to comply with the regulations regarding exposure to
RF Energy.
SAR was measured with the unit transmitting at its maximum certified
RF power. Often, however, during normal operation the unit will transmit
much less than maximum power. Transmit power is controlled
automatically and, in general is reduced as you get closer to a cellular
base station. This reduction in transmit power will result in a lower RF
energy exposure and resulting SAR value.
FCC RF Safety Statement In order to comply with FCC RF exposure
safety guidelines, users MUST use one of the following types of
bodyworn accessories.
1. A Palm™ brand body-worn accessory that has been tested for SAR
compliance and is intended for use with this product.
2. An accessory that contains NO metal (snaps, clips, etc) and provides AT
LEAST 1.5 cm of separation between the users body and the unit.
Do NOT use the device in a manner such that it is in direct contact with
the body (i.e. on the lap or in a breast pocket). Such use will likely exceed
FCC RF safety exposure limits See www.fcc.gov/oet/rfsafety/ for more
information on RF exposure safety.
Responsible party
(North America) (Europe)
palmOne, Inc. Francois Bornibus
400 N. McCarthy Blvd. Buckhurst Court
Milpitas, CA 95035 London Road
USA Wokingham, Berkshire RG40 1PA,
www.palmOne.com UK
Antenna Care/Unauthorized Modifications Use only the supplied
integral antenna. Unauthorized antenna modifications or attachments
could damage the unit and may violate FCC regulations. Any changes or
modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Potentially Unsafe Areas Potentially explosive atmospheres: Turn off your
smartphone when you are in any areas with a potentially explosive
atmosphere, such as fueling areas (gas or petrol stations) or storage
facilities for fuel or chemicals.
Declaration of Conformity
Treo Model 650
palmOne declares that the above model of Treo smartphone is compliant
with the regulations below. The declaration applies to the smartphone and
its associated accessories (power supply, headset, and USB cable) where
applicable.
Maximum Scaled SAR Values (W/kg)
Band (MHz) 850 900 1800 1900
Head SAR: 1.51 1.39 .541 .943
Body SAR: 1.46 1.27 .421 .688
EMC ETSI EN 301 489-1 EN 301 489-7 (200-9)
ETSI EN 300 328 (2001-12) ANSI/IEEE C95.1 1992
EN 50360 (July 2001) EN 50361 (July 2001)
FCC OET Bulletin 65 Supplement C
Safety: EN 60950: 2000 (Jan-2000)
Radiated Emissions: EN 55022 Immunity: EN 55024