Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
113
Internet
to you via a special short message, an Over The Air (OTA) message. After
you have received the settings, you can start using the WAP application
or edit the settings as described below.
To define and edit WAP connections
1 Press the Menu key and select Tools > WAP access. A dialog opens.
2 Press New to create a new connection, and Edit to edit an existing connection.
A dialog opens. See Figure 64.
Figure 64
3 Press Close when you are ready.
Tip: The shortcut to define and edit WAP access points is Ctrl + Shift + X.
Name: Name of the connection. All your connections should have different
names. You can define each name freely.
Secure connection: Whether the security protocol TLS is used for the connection. The
options are Yes/No. Follow the instructions given to you by your WAP
service provider. See also Glossary term ’Transport Layer Security’ on page
197.
Note: Some secure connections use authentication procedures. If
authentication fails, you may need to download some certification keys.
Contact your WAP service provider for details.
Internet access: Choose from a selection list the IAP you wish to use for this
connection. If you have no IAPs, you create a new one by pressing New
Internet access. See page 99.
Gateway IP address: The IP address that the required WAP gateway uses.
To change WAP access points
1 To change WAP access points, press the Menu key and select Tools > WAP access.
A dialog opens.
2 Press Change to change the connection. A list opens.
3 Choose the connection from the list and press OK.
LindaDeepak_ri.fm Page 113 Monday, September 27, 2004 2:34 PM