Nokia RAE-3N Cell Phone User Manual


 
Copyright © 2004 Nokia. All rights reserved.
51
Phone
In this submenu, you can lock the communicator. Press Select and enter your lock
code. The communicator locks immediately. When communicator is locked, you can
make emergency calls to predefined numbers using the cover phone. You can also
answer incoming calls and make emergency calls using the Telephone application.
All other actions are blocked. Even if you remove and replace the battery and switch
on the phone, the communicator will remain locked. To unlock the communicator,
press Unlock and enter the lock code. For more information on locking and other
security options, see ’Security’ on page 159.
IMPORTANT: The default lock code is 12345. For security reasons, it is
imperative that you change the lock code. Keep the code secret and in a safe place,
separate from the communicator. For information on changing the lock code, see
section ’Security’ on page 159.
Restore factory settings (3-4)
You can reset some of the menu settings to their original values. You need the lock
code for this function. This function will not affect stored phone numbers and
names, access codes, earpiece volume setting, call timers, cost counters, selected
application tones or SMS messages.
Call divert (Menu 4)
Tip: The icon is shown in the stand-by mode when you have activated the
Divert all voice calls.
This network service allows you to direct your incoming voice calls to another
phone number when you do not want to be disturbed, or when the phone is
switched off or outside the network coverage area. For details, see ’To divert voice
calls’ on page 65.
The options are: Divert all voice calls/Divert if busy/Divert if not answered/Divert if out of
reach/Divert if not available/Divert all fax calls/Divert all data calls/Cancel all diverts.
Select Activate to set the divert setting on if allowed by the network, Cancel to set
the setting off. Select Check status to check whether the divert is activated or not.
If you select Divert if not answered or Divert if not available, you can also select Set
delay to choose a delay time before the call is diverted. The options are 5 sec/10 sec/
15 sec/20 sec/25 sec/30 sec.
LindaDeepak_ri.fm Page 51 Monday, September 27, 2004 2:34 PM