Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
25
General information
It is recommended always to keep a charged battery in the communicator. Keeping
the battery charged maximises the lifetime of the backup battery supplying power
to the real-time clock of the communicator. In case the backup battery is drained,
it will be automatically charged the next time a charged battery is reconnected to
the communicator.
Always close the device cover before removing the battery. Closing the cover will
save all data.
Note: The battery does not fit into place if the SIM card is not correctly installed.
Do not force the battery into place! Check that you have inserted the SIM
card as described in the Getting Started Guide. If the SIM card is
incorrectly installed, remove it by pulling it out of the slot, and insert it
again.
Memory card
Tip: To protect the memory card with a password, see ’To lock a memory card’
on page 156.
You can use the memory card delivered in your sales package to manage your
documents, contacts databases, applications, backups, and so on.
Use the items on the memory card in the same way as corresponding items on the
communicator. You can, for example, install and remove software to and from the
memory card with the Install/Remove software application, and send messages to
contacts in the contacts directory of the memory card.
Note: Do not remove the memory card in the middle of an operation.
To insert the memory card
1 Close the device cover and make sure that the phone is switched off. If it is on,
press .
2 Open the hatch at the back of the communicator, using a minimum of two
fingers - one finger on each side of the hatch.
3 Slide the memory card under the memory card holder as shown in Figure 9. Make
sure that the gold contacts of the card are facing down.
LindaDeepak_ri.fm Page 25 Monday, September 27, 2004 2:34 PM