Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
Troubleshooting
184
If you fail to establish an infrared connection, transfer the file to a PC and use the
PC to print the document. Alternatively, you can fax the document to the nearest
fax machine. See ’To write and send a new fax’ on page 123.
14. PC connectivity problems
Make sure that PC Suite for Nokia 9210 Communicator is installed and running on
your PC. See the PC Suite Guide for more information.
If you use a cable connection, check that the cable is properly attached at both
ends.
If you use an infrared connection, check that the IR ports are facing each other and
the route between the ports is unobstructed.
Check that you are using the correct serial port (COM) on your PC.
For all other PC Suite problems, see the PC Suite guide and the PC Suite online help
‘Troubleshooting’ section.
15. Fax modem problems
When you use the communicator as a fax modem, make sure that the
communicator and the PC use the same baud rate. If you use the infrared
connection, the baud rate is set automatically. If you use the cable connection, set
the baud rate in the Fax modem settings. For the PC, the baud rate is set in the
connectivity software of the PC.
If you use the cable connection, fully compatible operation with all PC fax and
terminal software cannot be guaranteed. Consult your dealer. If you have problems
with your PC fax software, use the infrared connection.
If you have problems establishing a data connection with the remote modem, try
fixing the data transmission rate by using an AT command. Common AT commands
based on the ETSI 07.07 standard and supported by the Nokia 9210 Communicator
are listed in the atcomm.txt file on the CD-ROM supplied with the communicator.
For information on how to use the AT commands and fax modem drivers, consult
the documentation of the telecommunication or fax application that you use on
your PC.
16. Access code problems
The default lock code for Nokia 9210 Communicator is 12345. If you forget or lose
the lock code contact your communicator dealer.
If you forget or lose a PIN or PUK code, or if you have not received such a code,
contact your network service provider.
For information about Internet passwords, contact your Internet service provider.
LindaDeepak_ri.fm Page 184 Monday, September 27, 2004 2:34 PM