Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
23
General information
To charge the battery
Note: See important safety information on battery usage on page 24.
Tip: To check the current battery level, see the battery indicator on the
communicator or phone display.
1 Connect the charger cable to the bottom of the communicator, as shown in
Figure 8.
Figure 8
2 Connect the charger to the proper voltage AC wall outlet. While charging is in
progress, the battery level indicator scrolls on the phone display.
3 When the battery is fully charged, the bars stop scrolling and four bars are
displayed. You may now remove the charger plug from the communicator.
Note: You can use all the features of the communicator during charging.
When the battery level is low and only a few minutes of operation time remain, a
warning tone will sound, and the message BATTERY IS LOW will be repeated at
regular intervals on the phone display. When the charge level becomes too low for
operation, the RECHARGE BATTERY message will be displayed, accompanied by a
warning tone. If you do not connect the communicator to a charger, the
communicator switches itself off.
Note: When you connect a communicator with a fully discharged battery to a
charger, it will take 30-60 seconds before the CHARGING message
appears on the display and the battery indicator bar starts scrolling. After
that, it may take 10-30 seconds before you can switch the phone on.
LindaDeepak_ri.fm Page 23 Monday, September 27, 2004 2:34 PM