Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
Telephone
68
Advanced settings
1 Press the Menu key and select Settings > Advanced….
2 Define the following options:
Call costs page
Tip: To see the phone serial number, press the Menu key and select Tools> Serial
number (IMEI). Your network operator may ask you for this information.
If your network supports the call charging display service, use this page to change
call charge settings and to view cost counters. Your communicator will prompt you
for your PIN2 code. If this page is dimmed, your SIM does not support this network
service.
Figure 26
Display credits: Determines the information about call costs shown in the call
display during a call. The options are No/Used/Remaining. Credits are
amounts of money, measured either in units or currency.
Currency: Enter a maximum of three characters to indicate your choice of currency.
You can enter numbers or letters. For example, you can enter ‘FIM’ for
Finnish currency. This field is used with Unit price below and with Show in
currency.
Unit price: If you use ‘units’, enter a decimal number for the price of each charging
unit. You must also complete the Currency field above.
Maximum cost limit: You have two options: No limit or a value that you can define
in the field. You can define the limit in either units or in currency. If you
are in a call when the cost limit is reached, the call ends. You cannot make
any more calls. You see a note on the display before and after the call limit
is reached.
Press Calculate costs: The information in this dialog is:
Last call: - The cost of the last call made.
All calls: - The cost of all calls made since the cost counter was reset. See
Figure 27.
LindaDeepak_ri.fm Page 68 Monday, September 27, 2004 2:34 PM