152 Chapter 5
C:\Spk\Ref\RefGuideRevE\CdmascrnE2.fm
CDMA Measurements - Screens and Control Fields
Control Fields for CDMA Measurements
Analyzer (CDMA analyzer)
The Analyzer field controls three functions:
• Arm Meas arms the CDMA analyzer. The CDMA analyzer needs to
be armed only when Single (see below) is selected.
• Single/Cont selects between “single” measurements and
“continuous” measurements.
— When Single is chosen, you must arm each measurement by
selecting the Arm Meas field (see above).
— When Cont (continuous) is chosen, measurements are
automatically armed.
The default selection is Cont.
• Disarm disarms the CDMA analyzer during single operation. To stop
continuous measurements, select Single. Selecting Disarm does not
prevent the analyzer from being re-armed during continuous
measurements
Screens on which this field is present
CDMA ANALYZER
Analyzer (code domain analyzer)
This field is used to arm or disarm measurements when making a
single measurement (does not affect continuous measurements).
Selecting Disarm stops the analyzer during a single measurement.
See “Measurement” on page 163 for more information.
Screens on which this field is present
COD DOM (Code Domain Analyzer): main controls menu
Anl Dir
This field is used to select the type of signal (forward or reverse link) to
analyze.
• Fwd sets the analyzer to look for base station transmitter data
(forward link).
• Rev sets the analyzer to look for mobile transmitter data (reverse
link).
Default selection: Fwd
Screens on which this field is present
CDMA ANALYZER